ผลการค้นหา

against

แปลว่าตัดกับ (ผนัง), ทวน (น้ำ), ตรงกันข้าม, กั้น, ปะทะ

prejudice the right

แปลว่าทำให้เสียสิทธิ

Insurance against Injury to Persons and Damage to Property

แปลว่าประกันการบาดเจ็บของบุคคล และความเสียหายของทรัพย์สิน

Butt Welding

แปลว่า(english) Joining two edges or ends by placing one against the other and welding them.

Bolster (die block)

แปลว่า(english) A “tool” or reinforcing part which supports the backer-which, in turn, supports an extruding die against the pressure of extrusion.

Backer (back-up plate)

แปลว่า(english) A “tool” or reinforcing part, which presses against the outer surface of an extrusion die, supporting it against the pressure of the extruding metal. The backer has an opening larger than the die aperture, allowing the extruded product to emerge without marring its soft surface.

Cold Joint

แปลว่า(Concrete Engineering) A visible lineation which forms when the placement of concrete is delayed. The concrete in place hardens prior to the next placement of concrete against it.

Blast Cleaning (blasting)

แปลว่า(english) A process for cleaning or finishing metal objects by use of an air jet or centrifugal wheel that propels abrasive particles (grit, sand, or shot) against the surfaces of the workpiece at high velocity.

Blasting (Blast Cleaning)

แปลว่า(english) A process for cleaning or finishing metal objects by use of an air blast or centrifugal wheel that throws abrasive particles against the surface of the work pieces. Small, irregular particles of steel or iron are used as the abrasive in grit blasting, and steel or iron balls in shot blasting.

Construction Joint

แปลว่า(Concrete Engineering) The contact between the placed concrete and concrete surfaces, against or upon which concrete is to be placed and to which new concrete is to adhere, that has become so rigid that the new concrete cannot be incorporated integrally by vibration with that previously placed. Unformed construction joints are horizontally placed or nearly so.

Bend Test

แปลว่า(english) Various tests which is used to ascertain the toughness and ductility of a metal product, in which the material is bent around its axis and/ or around an outside radius. A complete test might specify such a bend to be both with and against the direction of grain. For testing, samples should be edge filed to remove burrs and any edgewise cracks resulting from slitting or shearing. If a vice is to be employed, then you must line the jaws with some soft metal, to permit a flow of the metal in the piece being tested.