ผลการค้นหา

Measurement

แปลว่า(Software Engineering) collecting quantitative data about the software or the software engineering processMetrics

Architectural design

แปลว่าan activity that attempts to layout the module "floor plan" for the software

Project size

แปลว่า(Software Engineering) an indication of the overall effort to be expended or the number of people working on the project

Shear strain:

แปลว่า(english) Strain measuring the intensity of racking in the material. Shear strain is measured as the change in angle of the corners of a small square of material.

Actual Weight

แปลว่า(english) The customer buys by the actual (scale) weight of the steel. The theoretical weight is used in estimating, however, it is not to be used for billing.

Architecture

แปลว่า(Software Engineering) the overall structure of software components, the data and/or content that components manipulate, and the relationships between them

Bending Angle

แปลว่า(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

Stratosphere

แปลว่า(Environmental Engineering) The atmosphere from approximately 12 km to 70 km. The temperature of the atmosphere increases in this region.Strong acid

Boring Tool

แปลว่า(english) A cutting tool in which the tool bit,the boring bar and in some cases the tool holder are incorporated.

Bow

แปลว่า(english) The lateral deviation from straightness

Bent Axis Pumps

แปลว่า(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.

Bottle Top Mold

แปลว่า(english) Ingot mold, with the top constricted; used in the manufacture of capped steel, the metal in the constriction being covered with a cap fitting into the bottle-neck, which stops rimming action by trapping escaping gases.