ผลการค้นหา

คำศัพท์ช่างภาษาอังกฤษ - ไทยคำศัพท์/สำนวน ทั้งหมดบทความ
ค้นเจอ 870 รายการ

Quality function deployment (QFD)

แปลว่า(Software Engineering) a technique that translates the needs of a customer in technical requirements for software by assessing the value of each requirement

Backing Sand

แปลว่า(english) The bulk of the sand in the flask. The sand compacted on top of the facing sand that covers the pattern.

rear axle torque arm

แปลว่าคานยึดท่อเพลาท้าย

clutch release arm rod

แปลว่าก้านต่อหรือสายท่ออ่อนปล่อยคลัทช์

Bending Angle

แปลว่า(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

Chair(s)

แปลว่า(Concrete Engineering) In concrete formwork, the support for the reinforcing steel.

Blister 2

แปลว่า(english) A defect in metal, on or near the surface, resulting from the expansion of gas in a subsurface zone. Very small blisters are called pinheads or pepper blisters.

BALL VALVE

แปลว่า(english) A valve that may be used to divert the flow of fluid in a passage. Most normally configured in a two-way pattern that is either open or closed.

Bottle Top Mold

แปลว่า(english) Ingot mold, with the top constricted; used in the manufacture of capped steel, the metal in the constriction being covered with a cap fitting into the bottle-neck, which stops rimming action by trapping escaping gases.

Bleeding, Bleed Water

แปลว่า(Concrete Engineering) A form of segregation in which some of the water in a mix tends to rise to the surface of freshly placed concrete. Known also as water gain.

Blowhole

แปลว่า(english) A defect in a casting caused by trapped steam or gas.

Bright Annealing 2

แปลว่า(english) The process of annealing in a protective atmosphere so as to prevent discoloration of the bright surface desired.

 ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด