ผลการค้นหา

be not sure* *be not sure *be not sure*
คำศัพท์ช่างภาษาอังกฤษ - ไทยคำศัพท์/สำนวน ทั้งหมดบทความ
ค้นเจอ 123 รายการ

Bit, Tool (cutter)

แปลว่า(english) A hardened steel bar or plate that is shaped accordidng to the operation to be performed and the material to be machined.

Base Metal

แปลว่า(english) (1) The metal present in the largest proportion in an alloy; (2) the metal to be brazed, cut or welded; (3) after welding the part of the metal that was not melted during the process.

Non-agitating Unit

แปลว่า(Concrete Engineering) A truck-mounted unit for transporting ready-mixed concrete short distances, not equipped to provide agitation (slow mixing) during delivery.

Secondary standards

แปลว่า(Environmental Engineering) Recommended drinking water quality standards which relate to aesthetics and/or health. These standards are recommended, not required. See primary standards.

Backoff

แปลว่าRemoval of part of coil from entry end of unit; may be necessitated by a defect in coil or by a wreck in the mill, etc. Backoff weight is the part of the coil that is removed and not finished/produced.

Brite

แปลว่า(english) 1) Regular galvanize coating (not minimized spangle or JP). 2) Rolls that have no grit; smooth finish on surface of steel.

Butt end

แปลว่า(english) The residual portion of an extrusion billet that is not forced through the die at the end of the extrusion cycle.

Project scope

แปลว่า(Software Engineering) a statement of basic requirements of the software to be built

Entrapped Air

แปลว่า(Concrete Engineering) Air in concrete which is not purposely en-trained, Entrapped air bubbles are normally much larger and more irregular than entrained air bubbles.

Distributed load:

แปลว่า(english) An external force which acts over a region of length, surface, or area: essentially any external force which is not a concentrated force.

Bloom 2

แปลว่า(english) A semi-finished hot rolled product, rectangular in cross section, produced on a blooming mill. For iron and steel, the width is not more than twice the thickness, and the cross-sectional area is usually not less than 36 sq. in. Iron and steel blooms are sometimes made by forging.

Work flow

แปลว่า(Software Engineering) the sequence of tasks that are required to accomplish some activity or action; often (but not always) used in conjunction with software process models

 ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด