ผลการค้นหา

Back End

แปลว่า(english) 1) Usually refers to the entry end of process lines. 2) The outside lap 2) of the produced coil, or the inside lap of the consumed coil.

Temper

แปลว่า(Concrete Engineering) The addition of water to the cement mix whether at the batch plant, during transit or at the jobsite to achieve the specified water to cement ratio.

Bent Axis Pumps

แปลว่า(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.

Chair(s)

แปลว่า(Concrete Engineering) In concrete formwork, the support for the reinforcing steel.

Climatology

แปลว่า(Environmental Engineering) The study of the climate, how the earth's atmosphere performs over long periods of time.

Base

แปลว่า(english) The steel or concrete pedestal on which the coils are stacked during the batch annealing process.

Inertial Force:

แปลว่า(english) A fictitious force used for convenience in visualizing the effects of forces on bodies in motion. For an accelerating body, the inertial force is considered as a body force whose resultant acts at the object's center of gravity in a direction opposite the acceleration. The magnitude of the force is the mass of the object times the magnitude of the acceleration.

Rotation:

แปลว่า(english) Motion of an object where the path of every point is a circle or circular arc. A rotation is defined by a point and vector which determine the axis of rotation. The direction of the vector is the direction of the axis and the magnitude of the vector is the angle of rotation.

Big Winch

แปลว่า(english) The tool used to spot (or position) the rail cars for unloading. It is located on the north end of the unloading area.

Base Metal

แปลว่า(english) (1) The metal present in the largest proportion in an alloy; (2) the metal to be brazed, cut or welded; (3) after welding the part of the metal that was not melted during the process.

Breakout

แปลว่า(english) An accident caused by the failure of the walls of the hearth of the furnace resulting in liquid iron or slag (or both) flowing uncontrolled out of the blast furnace.

whichever is the earlier

แปลว่าสิทธิยึดหน่วง